![]() ![]() Also ‘edit’ mode is activated once drawing is finished. To start editing select geo-fence in a list on ‘Geo-fences’ tab and click ‘edit’ button. Once finished click ‘Save’ to save changes to the database. This also works for notifications - geo-fence enter/exit events are posted only for configured devices. On map these geo-fences are visible only when either it is selected in geo-fences list or when specific device is selected (in such case all geo-fences for the device will be shown). Geo-fence will be applied to devices selected on ‘devices’ tab. This class is selected by default.ĭevice-specific - when ‘Apply to all devices’ is unchecked. On map these geo-fences are always visible. This works for notifications as well - user will receive notification when any accessible device enters/exits this geo-fence. Geo-fence will be applied to all accessible devices despite any settings on ‘Devices’ tab. Global - when ‘Apply to all devices’ is checked. IMPORTANT NOTE: Check box ‘Apply to all devices’ changes class of geo-fence. There are two ways to get back to ‘drawing’ mode from here: ‘clear’ drawing or change geo-fence type (which also clears drawing). Once drawing is finished it goes to ‘edit’ mode, which has formatting applied. ![]() Once center point is put drawing finishes.įormatting (color, line width) is not applied while drawing from scratch.
0 Comments
Leave a Reply. |