![]() ![]() ![]() After flashing firmware, it is good practice to reset the EEPROM. Noted above but after flashing, run this GCODE from the SD card. If 115200 does not work, change to 250000 and try again.ĮEPROM RESET (this gcode should be ran after flashing firmware) Please note that the baud rate can be 250000 or 115200 depending on your firmware version. The display will say Uploading until it finishes (takes a few minutes) Configure as shown below, select the appropriate. hex file and choose "Save Link As" X LOADER is an easy to use hex updater. hex file from Github, click on the Hex Files directory then right click on your appropriate. SCREEN FILES Dark Theme and other functions added You must move one of the Z cables from Z to E1 on the motherboard for this to function correctly and add G34 into starting script after G28.
0 Comments
Leave a Reply. |